Understanding The Terms Of Spousal Support
May 10, 2018
Villas Are A Great Idea For A Honeymoon
May 10, 2018

The Top Tips For Installing Fog Lights

Installing new fog lights on a vehicle is one method of enhancing visibility in poor outdoor conditions. The majority of fog light kits provide detailed instructions on installation to assist people who do not have any or have little wiring experience. Contrary to belief, installation of fog lights will vary according to the car model, and this can make this a difficult task to accomplish. This article will provide top tips for installing fog lights effectively on any model.

1. Choosing The Fog Lights

When selecting the fog lights, it is essential to consider your states local regulations. Certain areas have restrictions regarding the colour and type of fog lights a person can install. Always check the regulations to ensure that the lights comply with the rules and that they are approved for use by the state Department of Transportation.

In addition to the state regulations, it is essential that you consider the type of light and how it will fit your vehicle. Currently, there are three different types of fog lights: the grill mount, the bumper mount, and the rack mount. The grill mount is a larger and round type of fog light that is installed on the front grill. It is typically seen with SUVs and trucks. The bumper mounts are rectangular or round in shape and are often used to replace stock fog lights. Finally, the rack mount is a round light that is mounted above the car or onto the front brush guard. The rack mount is also seen mostly on SUVs and trucks.

2. Installing The Fog Lights

The first step to effectively installing fog lights is to ensure that the vehicle is parked and switched off. Ideally, the car should be parked on level ground as this makes installation much simpler.

Next, open the bonnet or hood to expose the vehicle’s wiring. The bumper mount-style fog lights are placed below headlights, so it is recommended that you review the vehicle manual if you have problems locating the lights. Once the lights have been identified, disconnect the fog light switch from the car’s power system. The disconnection should be done by detaching a clip.

Once all disconnections are performed, you need to remove the bolt, washer, and nut. This allows you to successfully remove fog light housing in the vehicle. It is vital that you hold onto these parts until the fog light installation is finished. When removing the housing, be careful not to scratch the vehicle’s bumper. When installing roof mount or grill mount-style lights, try lifting away from the car to avoid damaging the car body or roof.

Inserting the new fog light involves fitting the housing into the gap left by the old fog light. If the new light does not fit, then you may have bought an incorrectly sized light. If the fog light does fit, insert the light followed by the bolt. To install the bolt you need to thread the washer and the nut over the bolt, tightening them with a wrench or ratchet. It is vital that you do not over-tighten the items, or you could cause damage to the fog light or car. Also Read Benefits of Using LED Lights .

Once the fog light is in place, reconnect the light switch utilizing the clip. The new light should now be adequately powered by the vehicles power system. To test the new fog lights, start the vehicle’s ignition. If the lights turn on, ensure that the angle of the fog lights is suitable for visibility and do not shine in other drivers’ eyes.

Final Words

As can be seen, installation of fog lights may seem complicated but can be quite simple if following a procedure. Using the information above, you can perform the installation procedure easily on any type of vehicle. Find more information at  Diodedynamics.com .

Comments are closed.